U-Weld Adjustable Spindle Kit with Heim Joints

This kits comes with the option of offset or even spindle shaft length. The kit contains everything you need to bolt to your spindle plate.
Offset Spindle Set: The caster blocks have 2 holes, that are 2-1/2″ apart. The heim hole is 1/2″ and the bottom hole is 3/8″. If your spindle plate has this hole pattern, this kit should work fine. The spindle shafts length are 4-11/16″ and 3-1/4″.
Even Spindle Set: The caster blocks have 2 holes, that are 2-1/2″ apart. The heim hole is 1/2″ and the bottom hole is 3/8″. If your spindle plate has this hole pattern, this kit should work fine. The spindle shafts length are 3-1/4″
Long Even Spindle Set: The caster blocks have 2 holes, that are 2-1/2″ apart. The heim hole is 1/2″ and the bottom hole is 3/8″. If your spindle plate has this hole pattern, this kit should work fine. The spindle shafts length are 4-11/16″
Included:
(2) 1/2″ Male Tie Rod End (Right Hand Thread)
(2) Replacement Bearing for Heim in Castle Block
(2) Aluminum Caster Block
(2) Adjustable Kingpin Bolt
(2) 5/8″ Castle Nut for Spindle (5/8-18)
(6) 1/2″ Castle Nut (1/2-20)
(4) Reusable Cotter Pins Small
(2) Spindle Arm
(2) Adjustable Spindle Barrel (5/8-18)
(2) Spindle Shaft (see options)
(2) 5/8-18 Jam Nut
(2) 1/2-20 Lock Nut
(2) 3/8 x 1″ FHCS Bolt
(2) 1/8″ Roll Pin