DIYMINIBIKES

This kits comes with the option of offset or even spindle shaft length. The kit contains everything you need to bolt to your spindle plate.
Offset Spindle Set: The caster blocks have 2 holes, that are 2-1/2″ apart. The heim hole is 1/2″ and the bottom hole is 3/8″. If your spindle plate has this hole pattern, this kit should work fine. The spindle shafts length are 4-11/16″ and 3-1/4″.
Even Spindle Set: The caster blocks have 2 holes, that are 2-1/2″ apart. The heim hole is 1/2″ and the bottom hole is 3/8″. If your spindle plate has this hole pattern, this kit should work fine. The spindle shafts length are 3-1/4″
Long Even Spindle Set: The caster blocks have 2 holes, that are 2-1/2″ apart. The heim hole is 1/2″ and the bottom hole is 3/8″. If your spindle plate has this hole pattern, this kit should work fine. The spindle shafts length are 4-11/16″
Included:
(2) 1/2″ Male Tie Rod End (Right Hand Thread)
(2) Replacement Bearing for Heim in Castle Block
(2) Aluminum Caster Block
(2) Adjustable Kingpin Bolt
(2) 5/8″ Castle Nut for Spindle (5/8-18)
(6) 1/2″ Castle Nut (1/2-20)
(4) Reusable Cotter Pins Small
(2) Spindle Arm
(2) Adjustable Spindle Barrel (5/8-18)
(2) Spindle Shaft (see options)
(2) 5/8-18 Jam Nut
(2) 1/2-20 Lock Nut
(2) 3/8 x 1″ FHCS Bolt
(2) 1/8″ Roll Pin